Upgrading Firmware Using A Usb Mass Storage Device - Avaya G250 Administration

Note:
This command is not supported on the G250.
Note:
Use the copy tftp module command, followed by the module number of the module
●
you want to upgrade, to upgrade the firmware on a media module from a TFTP server.
Use the copy tftp SW_imageA command to upgrade the G250/G350 firmware into
●
Bank A from a TFTP server.
Use the copy tftp SW_imageB command to upgrade the G250/G350 firmware into
●
Bank B from a TFTP server.
Use the copy tftp EW_archive command to upgrade the Java applet for Avaya G350
●
Manager software from a TFTP server.
Note:
This command is not supported on the G250.
Note:
When using FTP or TFTP commands, you must use the specific path of the file on the FTP or
TFTP server according to the home directory of the service (FTP or TFTP) that you are using.
For example, to upgrade the firmware of an MM710 media module in slot 2 from a TFTP server
with the IP address 192.1.1.10, where the home directory is c:\home\ftp\ and the upgrade file is
located in the directory c:\home\ftp\version, use the following command:
copy tftp module \version\mm710v3.fdl 192.1.1.10 2
Note:
When downloading firmware from the S8300, use only the file name, without the
Note:
directory path, in the command line. Otherwise, the procedure will fail. For
instance, in the example above, you must use the following command:
copy tftp module mm710v3.fdl 192.1.1.10 2
Note:
When downloading firmware from the S8300 using TFTP, you may need to
Note:
enable the TFTP service in the Set LAN Security parameters of your web server.
The following example downloads a firmware version with the path and file name C:\g350.net
from an FTP server with the IP address 149.49.134.153 to Bank A of the G350:
copy ftp SW_imageA C:\g350.net 149.49.134.153

Upgrading firmware using a USB mass storage device

You can upgrade firmware using a USB mass storage device.
Upgrading firmware via the USB mass storage device "copy" command
1. Obtain an upgrade file from Avaya and place it on your PC.
2. Insert the USB mass storage device into the PC's USB port, and copy the firmware file(s)
to the USB mass storage device.
Software and Firmware Management
Issue 3 February 2007 87