Administering Trunk-Group Parameters - Avaya G250 Administration

Media gateways
Hide thumbs Also See for G250:
Table of Contents

Advertisement

15. Type show to check the BRI administration.
The report lists the BRI parameters:
Name = BRI-SLS1
BRI
Interface
---
---------
v401
Dir-NumberA Dir-NumberB Spid-A
----------- ----------- -------------- --------------
3033234567
16. Type exit to leave the BRI context in SLS.

Administering Trunk-group parameters

1. Type trunk-group tgnum group-type, where tgnum is any number between 1-2000.
group-type can be any of the following:
loop-start (analog)
did (analog)
ground-start (analog)
bri (ISDN basic rate)
t1-isdn (ISDN primary rate on 1.544 Mbps facility)
e1-isdn (ISDN primary rate on 2.048 Mbps facility)
t1-inband (non-ISDN rate on 1.544 Mbps facility)
e1-inband (non-ISDN rate on 2.048 Mbps facility)
The command line prompt changes to super-survivable-call-engine/
trunk-group-<tgnum>. If you want to remove the trunk group from the SLS
administration, type exit to leave the second-level trunk-group context to return to the
(super-survivable-call-engine)# context, and then type clear trunk-group
tgnum.
You can create a trunk group that does not have any assigned members. Once a valid port
is assigned as a trunk group member, this trunk group then becomes active and may be
employed by SLS call processing for incoming/outgoing trunk operation. The
slot-configuration table will be used (together with the port capacity for the given module)
to determine the validity of a port assignment at administration time.
As a result, there may not be more active trunk groups than there are physical trunk
members within a given gateway. In addition, a combo-port may only be used for one
active assignment. For example, the analog station/DID trunk ports may be either
allocated to serve as an analog station or as an analog DID trunk, but not both.
Side
Country
----
--------
user
a
country1
3033234568 30332345671111 30332345681111
Bearer
Compand
Endpt-Init
------
-------
----------
speech
ulaw
Spid-B
Configuring SLS
Layer1-Stable
-------------
yes
Issue 3 February 2007
yes
161

Advertisement

Table of Contents
loading

This manual is also suitable for:

G350

Table of Contents