Defining The Default Gateway; Configuring The Media Gateway Controller (Mgc) - Avaya G250 Administration
Media gateways
Hide thumbs
Also See for G250:
- Administration manual (840 pages) ,
- Reference (812 pages) ,
- Administration (620 pages)
Table of Contents
Advertisement
Configured PMI — the PMI that the G250/G350 is configured to use after reset, as
●
defined in the startup configuration file
If you use this command after you reset the G250/G350, both the Active and the
Configured PMI should be the same IP address.
7. Use the following commands to configure other identification information:
Use the set system contact command to set the contact information for the G250/
●
G350.
Use the set system location command to set the location information for the
●
G250/G350.
Use the set system name command to specify the name of the G250/G350.
●
Defining the default gateway
The G250/G350 uses a default gateway to connect to outside networks that are not listed on the
G250/G350's routing table. To define a default gateway, use the ip default-gateway
command, followed by either the IP address or name (type and number) of the interface you
want to define as the default gateway.
The following example defines the interface with the IP address 132.55.4.45 as the default
gateway:
ip default-gateway 132.55.4.45
The following example defines Serial interface 5/1:1 as the default gateway:
ip default-gateway Serial 5/1:1
Configuring the Media Gateway Controller (MGC)
The Media Gateway Controller (MGC) controls telephone services on the Avaya G250/G350
Media Gateway. You can use a media server with Avaya Communication Manager software as
an MGC. The G250/G350 supports both External Call Controllers (ECC) and Internal Call
Controllers (ICC). An ICC is an Avaya S8300 Media Server that you install in the G250/G350 as
a media module. An ECC is an external media server that communicates with the G250/G350
over the network.
When the G250/G350 uses an ECC, it can use a local S8300 as a backup controller for
Enhanced Local Survivability (ELS). The S8300 functions in Local Survivable Processor (LSP)
mode. If the ECC stops serving the G250/G350, the S8300 takes over the service.
Defining the default gateway
Issue 3 February 2007
71
Advertisement
Table of Contents
