Avaya G250 Administration page 108

Configuring Standard Local Survivability (SLS)
Using the Hold button
1. Press the Hold button on the analog phone.
2. To return to the call, press the Hold button.
Using the Flash button
1. Press the Flash button on the analog phone.
You will hear a dial tone; the other party hears silence.
You can leave the call on Hold or transfer the call. Press the Flash button twice to return to
the call.
2. Dial the Feature Access Code for Hold.
At this point you can leave the call on Hold or transfer the call.
3. To return to the call, press the Flash button again.
The call is re-established.
Note:
Either party can put the call on Hold or return to the call.
Note:
Using the switchhook button
1. Press the switchhook once.
You will hear dial tone.
2. Dial the Feature Access Code (FAC) for Hold.
This places the call on Hard Hold which prevents you from transferring the call. To return to
the call, dial the FAC for Hold.
3. You can do any of the following:
Return to the call by dialing the FAC for Hold.
●
The call is re-established.
Hang up.
●
Your phone will ring to notify you that you have a call on Hold. When you lift the
receiver you will hear a dial tone and can perform any of the activities listed in Step 3.
Dial a third party by dialing the number and flashing the switchhook once (you will hear
●
a stutter dial tone). Dial the FAC for Hold (the second call is now on Hold and the first
call is re-established). If you want to toggle between the first and second calls, press
the switchhook and dial the FAC once each time you want to change calls.
108 Administration for the Avaya G250 and Avaya G350 Media Gateways