Pppoe Commands - Avaya G250 Administration

9. Use the copy running-config startup-config command to save the
configuration.
10. To shut down the port and the PPPoE client (if configured), use the shutdown command
in the interface context (optional).

PPPoE commands

Table 41: PPPoE commands
Commands
interface
FastEthernet 10/2
encapsulation pppoe
ip address
ip address
negotiated
ppp pap-sent
ppp chap hostname and
ppp chap password
show ppp
authentication
copy running-config
startup-config
pppoe-client service
name
Description
Enters the content of the fast Ethernet Interface.
Changes the encapsulation to PPPoE.
You must change the encapsulation to PPPoE before
configuring an IP address on the interface.
Configures an IP address and subnet mask for the interface.
In most cases, PPPoE tunnels require a 32-bit subnet mask.
Obtains an IP address via PPP/IPCP negotiation. You cannot
configure PPP/IPCP address negotiation if DHCP address
negotiation is already configured on the interface.
Configures a PAP authentication method.
Authentication parameters do not appear in the startup or
running configuration files.
Configures a CHAP authentication method.
Authentication parameters do not appear in the startup or
running configuration files.
Used to view authentication status.
Stores authentication parameters in NVRAM.
Forces the PPPoE client to connect only to access
concentrators that support a specific service name.
Use the no form of this command to deactivate connection to
a specific service name. When connection to a specific service
name is deactivated, the PPPoe client attempts to
automatically discover the service name by initiating PADI
frames with a blank service name.
Initial WAN configuration
1 of 2
Issue 3 February 2007 227