Avaya G250 Administration page 219

If you do not specify an IP interface number for the first serial interface that you define on a
channel group, the G250/G350 automatically assigns IP interface number 0. For each
additional serial interface that you define on the channel group, use a different IP interface
number. For example:
- interface Serial 2/1:1 enters a serial interface on the media module in slot
number 2, on port number 1, with channel group number 1.
- interface Serial 5/1:2.3 enters a serial interface on the media module in slot
number 5, on port number 1, with channel group number 2, and with IP interface
number 3.
Note:
If you use the framing unframed command in Step 3 for an E1 port, a channel
Note:
group is automatically created on the entire E1 bandwidth. The channel group
has the number 0. In Step 6, use the command interface Serial s/p:0
where s is the slot number and p is the port number.
Note:
After the serial interface is created, its default encapsulation is PPP.
Note:
9. Configure the interface encapsulation:
- By default, the serial interface uses PPP encapsulation.
10. Use the ip address command to configure the IP address and subnet mask of the
interface.
11. Type exit to return to general context. The prompt returns to:
G350-001(super)#
12. If needed, repeat Step 7 through Step 9 to configure additional IP interfaces on the same
channel group.
13. If needed, repeat Step 5 through Step 9 to configure additional channel groups on the
same E1 or T1 port.
Note:
The G250 only supports a single channel group.
Note:
14. Test the WAN configuration.
15. Use the copy running-config startup-config command to save the
configuration.
Initial WAN configuration
Issue 3 February 2007 219