2. Use the set logging session condition saa command to view all RTR messages
of level Info and above.
G350-001# set logging session condition saa Info
Done!
CLI-Notification: write: set logging session condition saa Info
3. Use the set logging session condition tracker command to view all object
tracker messages of level Info and above.
G350-001# set logging session condition tracker Info
Done!
CLI-Notification: write: set logging session condition tracker Info
Example of tracking a single remote device
Figure 22: Tracking a single remote device
1. The first step is to configure an RTR which tracks a remote device. In this case, RTR 5 is
configured to track the device at IP address 10.0.0.1:
G350-001(config)# rtr 5
G350-001(config-rtr 5)# type echo protocol ipIcmpEcho 10.0.0.1
G350-001(config-rtr icmp 5)# wait-interval 2 seconds
Done!
G350-001(config-rtr icmp 5)# fail-retries 3
Done!
G350-001(config-rtr icmp 5)# success-retries 1
Done!
G350-001(config-rtr icmp 5)# exit
G350-001(config)# rtr-schedule 5 start-time now life forever
2. The second step is to configure an object tracker which tracks the state of RTR 5:
G250-001(config)# track 1 rtr 5
G250-001(config-track rtr 1)# description "track rtr-5"
Done!
G250-001(config-track rtr 1)# exit
Object tracking
Issue 3 February 2007
263