Avaya G250 Administration page 139

Table 19: Feature Access Codes to assemble for SLS
Page Field Name
1 Contact Closure Open Code
1 Contact Closure Close Code
1 Contact Closure Pulse Code
1 Auto Route Selection
(ARS) Access Code1
1 Auto Route Selection
(ARS) Access Code2
1-16 ARS FAC
1 CAS Remote Hold/ Answer
Hold-Unhold Access Code
Collecting System parameters data
1. At the SAT, type list media-gateway and press Enter to display a list of administered
gateways.
2. Look for any of the following supported gateways in the Type field:
G250/G250-BRI/G250-DCP/G250-DS1
●
G350
●
3. Once you have determined the media gateway of interest, note its IP-Network-Region.
4. At the SAT, type display ip-network-region n, where n is the gateway's
administered IP-Network-Region.
Read the Codec-set field value from the IP Network Region form.
5. At the SAT, type display ip-codec-set n, where n is the Codec-set field value from
the IP Network Region form.
The report lists the supported codes in the Audio Codec field (summarized in
Note:
SLS only supports G.711 mu/A-law.
Note:
6. At the SAT, type display system-parameters features and press Enter to display
the Feature Related System Parameters form.
Notes
Used to open a contact closure relay.
Used to close a contact closure relay.
Used to pulse a contact closure relay.
Specifies the 1st access code for ARS table
routing.
Specifies the 2nd access code for ARS table
routing.
This is used instead of the 'Features' form ARS
FAC entry if the "Loc No." that correlates to the
gateway has an entry in this form, which
overrides the general ARS FAC(s).
Specifies the dial access code to provision a
hold bridge on the call involving this station user.
Successive access to this dial code causes the
feature to toggle between the "hold" and the
"un-hold" states.
Configuring SLS
Table
Issue 3 February 2007
20).
139