Avaya G250 Administration page 136

Configuring Standard Local Survivability (SLS)
Table 16: DS1 circuit pack data to assemble for SLS (continued)
*
Page Field Name
1 Side
1 Country Protocol
1 Protocol Version
1 DCP/Analog
Bearer Capability
1 Interface
Companding
1 ITN-C7 Long
Timers
* Page numbers might vary for your system.
3. Repeat the display ds1 location command and press Enter for each circuit pack
that you want to included in the SLS data set.
Collecting signaling groups data
Collect the information from the Communication Manager Signaling Group form
ISDN-PRI administration only:
Table 17: ISDN-PRI administration data to assemble for SLS
*
Page Field Name
1 Trunk Group for
Channel Selection
1 Associated Signaling
1 Primary D-channel
136 Administration for the Avaya G250 and Avaya G350 Media Gateways
Notes
Specifies QSIG glare handling when the 'interface' field is
set to 'peerslave.'
Specifies the Layer 3 signaling protocol used by the
country-specific service provider
Used in countries whose public networks allow multiple
Layer-3 signaling protocols for ISDN PRI service
Sets the Information Transfer capability in the Bearer
Capability IE of the SETUP message
Specifies the companding mode used by the far-end
switch.
Specifies whether the duration of Q.931 timers (T302 and
T302) is to be extended. This is only required for Russian
telecom applications and if Signaling Mode = isdn-pri.
Notes
Trunk group reference number association with trunk
group table
Specifies whether the D-channel is physically
associated in the DS1 facility. The 'enabled' setting is
when there is a D-channel present.
Specifies the gateway port ID where the D-channel is
located. For the gateways, the first component is the 3
digit gateway number, followed next by a 'v', followed by
the slot number, followed by 24 (T1) or 16 (E1).
2 of 2
(Table 17) for
1 of 2