Avaya G250 Administration page 167

insert1
●
insert2
●
insert3
●
insert4
●
Examples
set digit-treatment absorb1 removes the first digit from the incoming DID
●
trunk.
set digit-treatment blank removes any digit treatment from the trunk group.
●
8. For analog DID trunk groups or DS1 tie trunk groups, type set digits digits to define
the inserted digit string, where digits is the number of digits.
Note:
The number of digits must agree with the digit-treat parameter in the set
Note:
digit-treatment command. If the digit-treat parameter is insert3, then the
digits parameter for this command must be three digits in length.
9. Type set name name to identify the user name for the trunk group. Use the 1-27
character name as specified on the Communication Manager form (add
trunk-group n). Type the name string inside double quotes.
10. For ISDN trunks, type set codeset-display codeset to identify which Q.931
codesets are allowed to send display information to the user phone: codeset0, codeset6,
or codeset7.
11. For ISDN trunks, type set codeset-national codeset to identify which Q.931
codesets are allowed to send National Information Elements (IEs, or display information)
to the user phone: codeset6 or codeset7.
12. For ISDN trunks, type set channel-preference type to define how the Channel
Identification IE field is encoded, where type can be one of the following:
exclusive: The central office must have the ability to grant a call on this channel or
●
reject the call attempt.
preferred: The central office might offer the call request on another available channel.
●
13. For ISDN trunks, type set digit-handling method to define the order of
reception/transmission to be considered with the flow of inbound/outbound:
enbloc-enbloc, enbloc-overlap, overlap-enbloc, overlap-overlap.
Enbloc requires sending the entire collected digit string in one block.
Overlap sends the digits one at a time as they are collected.
14. For ISDN trunks, type set japan-disconnect yes | no to specify whether to
perform a disconnect sequence (CONNECT message followed by a DISCONNECT
message).
Configuring SLS
Issue 3 February 2007 167