Avaya G250 Administration page 357

A traceroute is performed per RTP session, 10 seconds after the session begins. A traceroute is
not performed if there is another active session to the same destination for which a traceroute
was already performed within the last 5 seconds.
1. Use the show rtp-stat traceroute command. You can filter the results according to
subnet address by adding destination-ip and specifying the remote subnet address
and subnet mask, or by rtp-statistics session index by specifying the rtp-statistics session
index. For example:
G350-001(super)# show rtp-stat traceroute destination-ip 10.2.5.0 255.255.255.0
Session ID: 1234
From: 123.21.11.5, To: 10.2.4.15, At: 2004-12-26,12:21:55
TTL HOP ADDRESS
--- ---------------
1 123.21.11.1
2 212.201.233.102
3 213.21.51.12
4 10.2.4.15
Session ID: 1234
From: 123.21.11.5, To: 10.2.4.5, At: 2004-12-26,13:30:15
Note:
The traceroute results are displayed in reverse order (most recent first).
Note:
Table 51: RTP traceroute results output
Field
Session ID
From
To
At
TTL
HOP ADDRESS
DELAY
DELAY
--------
2ms
65ms
110ms
175ms
Description
The RTP statistics index for the RTP session
The IP address of the G250/G350
The IP address of the session destination (in this case, a destination
within the specified subnet)
The time the traceroute is performed
The hop count and TTL field value of probe packets
The hop IP address
The round trip time per probe packet. Three probe packets are sent
per hop address, and the displayed value is the average of the three
round-trip times. An asterisk (*) indicates that the probe packet timed
out.
Configuring and analyzing RTP statistics
Issue 3 February 2007 357