Administering Bri Parameters - Avaya G250 Administration

12. Type set interface-companding type to set the interface to agree with the
companding method used by the far-end of the DS1 circuit for SLS mode, where type is
any of the following values:
alaw: A-law companding
●
ulaw: U-law companding
●
13. Type set long-timer yes | no to increase the duration of the T303 (call
establishment) timer, where:
yes: The T303 timer is extended from 4 seconds to 13 seconds
●
no: The T303 timer remains at 4 seconds
●
14. Type show to check the DS1 administration.
The report lists the DS1 parameters:
Name = 'Willow Steet 2'
DS1 Rate Signaling Channel Connect Interface Side Protocol Ver Bearer Cmpd Ltm
---- ---- --------- ------- ------- --------- ---- -------- --- ------ ---- ---
v4 1544
15. Type exit to leave the DS1 context in SLS.

Administering BRI parameters

1. Type bri slot-address, where slot-address is any permitted port.
The command line prompt changes to sls-bri <slot-address>. If you want to
remove the BRI link from the SLS administration, type exit to leave the second-level bri
context to return to the (super-survivable-call-engine)# context, and then type
clear bri slot-address.
2. Type set name name command to identify the user name for the DS1 trunk. Use the 1-27
character name, as specified on the Communication Manager form (add
trunk-group n). Type the name string inside double quotes.
3. Type set interface glare-mode to specify the glare-handling convention.
glare-mode can be any of the following values:
For Non-QSIG calls:
●
- network: If the gateway is connected to a host computer and encounters glare, it
overrides the far-end.
- user: If the gateway is connected to a public network and encounters glare, it
releases the circuit.
For QSIG calls:
●
- peerMaster: SLS overrides the other end when glare occurs.
- peerSlave: SLS releases the circuit when glare occurs.
isdnpri seq network user a country1
Issue 3 February 2007
Configuring SLS
a speech ulaw no
159