Accessing The Cli Via A Serial Modem - Avaya G250 Administration

Accessing the Avaya G250/G350 Media Gateway
2. Make sure the USB port is properly configured for modem use. For details, see
Configuring the USB port for modem use
3. From the remote computer, create a dialup network connection to the Avaya G250 or
G350 Media Gateway. Use the TCP/IP and PPP protocols to create the connection.
Configure the connection according to the configuration of the COM port of the remote
computer. By default, the G250/G350 uses PAP authentication. If your network has a
RADIUS server, you can use RADIUS authentication for the PPP connection. For more
information, see
4. Open any standard telnet program on the remote computer.
5. Open a telnet session to the IP address of the USB port on the G250/G350. For instructions
on how to set the IP address of the USB port (i.e., the USB interface), see
USB port for modem use
6. Configure the serial connection on the remote computer to match the configuration of the
USB port on the G250/G350 (see

Accessing the CLI via a serial modem

1. Connect a modem to the console port (CONSOLE) on the front panel of the Avaya G250/
G350 Media Gateway. Use an RJ-45 serial cable to connect the modem.
2. Make sure the console port is properly configured for modem use.
3. From the remote computer, create a dialup network connection to the Avaya G250/G350
Media Gateway. Use the TCP/IP and PPP protocols to create the connection. Configure
the connection according to the configuration of the COM port of the remote computer. By
default, The G250/G350 uses PAP authentication. If your network has a RADIUS server,
you can use RADIUS authentication for the PPP connection.
4. Open any standard telnet program on the remote computer.
5. Open a telnet session to the IP address of the console port on the G250/G350.
38 Administration for the Avaya G250 and Avaya G350 Media Gateways
Managing login permissions
on page 209.
Table
Table 1: The USB port settings:
Port setting
Baud
Data bits
Parity
Stop bits
Flow control
on page 209.
on page 44.
1).
Value
-
8
none
1
hardware
Configuring the