Avaya G250 Administration page 247

Table 42: Modem dial backup logging messages
Log Message Severity
Dialer Messages - Messages generated by the Dialer interface
Dialer 1 state is Debug
<state>
Dialer 1 trigger Informational
is <on/off>
Possible cause
The Dialer interface generates a
message when a change in its
operational state has been
detected. The default state for
the Dialer interface when it is
used as a backup interface for a
WAN link is Standby. When the
primary WAN link has failed and
the backup interface mechanism
is invoked, the state of the
Dialer interface changes to Up.
In a modem dial backup
scenario, the event triggering
the Dialer interface is a failure of
the primary WAN interface for
which the Dialer interface has
been configured as the backup
interface. When the primary
WAN interface has been
determined to be down, a
message is sent indicating the
occurrence of the triggering
event for the dialer. When the
primary WAN interface is
returned to an operational state,
a message is generated
indicating that the conditions for
triggering the dialer are no
longer being met, and that the
dialer can be brought down.
Modem dial backup
Action
None required.
None required.
1 of 6
Issue 3 February 2007 247