Up-Converting Sls Data To Release 4.0; Down-Converting Release 4.0 Sls Data - Avaya G250 Administration

7. Type show to check the incoming-routing administration.
The report lists the incoming-routing parameters for all dial patterns that have been
administered:
Match_pattern
-------------

Up-converting SLS data to Release 4.0

In order to re-use an SLS administration data set from an earlier release, you must convert it to
Release 4.0 compatibility.
1. Type copy ftp running-config and press Enter to restore the Release 3.x
translation file on the gateway.
2. Reset the gateway.
3. Type copy running-config startup-config and press Enter.
A gateway application reconstructs the CLI commands to use the Release 4.0 command
contexts and subcommand formats and saves the results in a new translation file.

Down-converting Release 4.0 SLS data

If you have a Release 4.0 SLS administration data set in which stations are administered with
station numbers greater than 7 digits, and you wish to apply that data set to Release 3.1-level
firmware on a gateway, you must re-administer the stations with extension numbers not
exceeding 7 digits.
Length Del
------ ---
234 7 3
235 7 3
Insert-digits Mode
------------- ------
5381000 enbloc
5381001 enbloc
Configuring SLS
tgnum
-----
98
99
Issue 3 February 2007 173