Avaya G250 Administration page 135

Media gateways

Hide thumbs Also See for G250:

Table of Contents

Table 15: Trunk group data to assemble for SLS (continued)

Calling Number

* Page numbers might vary for your system.

Collecting DS1 trunks data

1. At the SAT, type display ds1 location and press Enter to display the DS1

administration for a particular circuit pack location.

2. Gather DS1 information according to

Table 16: DS1 circuit pack data to assemble for SLS

Signaling Mode

Specifies how to fill the Calling Party Number and Called

Party Number IEs

Sets a destination station for routing incoming trunk group

Determines the method in which the

survivable-call-engine selects an available trunk from the

trunk group pool.

Specifies the Signaling Group Number that is the

manager of this ISDN trunk member.

for each DS1 facility.

Descriptive name often of the Service Provider or

destination of the DS1 facility

Selects the maximum transmission rate of the DS1 facility

Selects the signaling method deployed on the given DS1

E1 interface for ETSI and QSIG require sequential

encoding from 1 to 30.

This field appears when

Signaling Mode = isdn-pri

Bit Rate = 2.048

Connect = pbx

Specifies what is connected at the far-end of the DS1

Determines glare handling

Configuring SLS

Issue 3 February 2007