Avaya G250 Administration page 137

Table 17: ISDN-PRI administration data to assemble for SLS (continued)
*
Page Field Name
1 Trunk Board
1 Interface Id
* Page numbers might vary for your system.
Collecting administered ISDN-BRI trunks data
1. At the SAT, type display bri-trunk-board location and press Enter to display
the DS1 administration for a particular circuit pack location.
2. Gather ISDN-BRI administration information in
Table 18: ISDN-BRI administration data to assemble for SLS
*
Page Field Name
1 Name
1 Interface
1 Side
1 Country Protocol
1 DCP/Analog Bearer
Capability
2 Companding Mode
1 TEI
2 Directory Number A
Notes
This is needed only if the 'Associated Signaling' is
administered as 'no'. This does not apply to SLS on the
G250. Specifies the gateway port ID where the
D-channel is located. For the gateways, the first
component is the three digit gateway number, followed
next by a 'v', followed by one numeric character for the
slot number.
This is needed only if the 'Associated Signaling' is
administered as 'no'. This does not apply to SLS on the
G250. Specifies the channel of the DS1 circuit that
carries the D-channel for ISDN signaling. This is an
integer from '0' through '31'.
Table 18
Notes
Descriptive name often of the Service Provider or
destination of BRI facility
Determines glare handling
QSIG glare handling, when the interface field is
peerSlave
Specifies the Layer 3 signaling protocol used by
the country-specific service provider
Sets the Information Transfer capability in the
Bearer Capability IE of the SETUP message
Specifies the companding mode used by the far
end switch.
LAPD address assignment for TEI field.
Channel B1's directory number
Configuring SLS
for each location.
1 of 2
Issue 3 February 2007
2 of 2
137