Spanning Tree Configuration Examples - Avaya G250 Administration

Use the set spantree tx-hold-count command to set the value in packets used by
●
the spanning tree in order to limit the maximum number of BPDUs transmitted during a
hello-time period.
Use the set spantree version command to set the version of the spanning tree
●
protocol.
Use the show spantree command to display spanning-tree information.
●

Spanning tree configuration examples

The following example enables spanning tree on a port:
G350-003(super)# set port spantree enable 6/8
port 6/8 was enabled on spantree
The following example disables spanning tree on a port:
G350-003(super)# set port spantree disable 6/8
port 6/8 was disabled on spantree
The following example configures the version of the spanning tree default path cost used by this
bridge:
350-003(super)# set spantree default-path-cost common-spanning-tree
Spanning tree default path costs is set to common spanning tree.
The following example configures the time used when transferring the port to the forwarding
state:
G350-003(super)# set spantree forward-delay 16
bridge forward delay is set to 16.
The following example configures the time interval between the generation of configuration
BPDUs by the root:
G350-003(super)# set spantree hello-time 2
bridge hello time is set to 2.
The following example configures the amount of time an information message is kept before
being discarded:
G350-003(super)# set spantree max-age 21
bridge max age is set to 21.
Configuring spanning tree (G350 only)
Issue 3 February 2007 325