Configuring The Avaya Mm340 E1/T1 Wan Media Module - Avaya G250 Administration

2. Connect the WAN line to the media module. For more information, see Installing and
Upgrading the Avaya G250 Media Gateway, 03-300434 or Installing and Upgrading the
Avaya G350 Media Gateway, 03-300394.
3. Configure the WAN interface on the WAN media module.
- For the MM340, see
page 217.
- For the MM342, see
page 221.
4. By default, a G250/G350 WAN interface uses Point-to-Point Protocol (PPP). For
instructions on changing the default PPP parameters, see
5. If you want frame relay encapsulation on the WAN, configure frame relay. See
frame relay
6. Test the WAN configuration. See
connectivity
7. Use the copy running-config startup-config command to save the
configuration.

Configuring the Avaya MM340 E1/T1 WAN media module

For a list of G250/G350 default settings, see
1. Use the show controllers command to display the current settings (optional).
2. Use the show-ds command to check if the G250/G350 is configured for E1 or T1
operation.
3. Use the ds-mode command to set the mode of the G250/G350 to E1 or T1. Changing the
line type requires resetting the module. The default value is T1.
4. Use the controller ds-mode slot/port command to enter controller context for the
port to be configured. The prompt changes to:
G350-001(super-if:Serial
where s is the slot number of the media module, and p is the port number.
5. Use the following commands to change the clock source, frame type, linecode, or cable
length parameters from the default settings:
- For T1 mode:
clock source line|internal (default is line)
framing sf|esf (default is sf)
linecode ami|b8zs (default is ami)
cablelength long|short (default is long, gain26, 0db)
Configuring the Avaya MM340 E1/T1 WAN media module
Configuring the Avaya MM342 USP WAN media module
on page 229.
Verifying the WAN configuration and testing
on page 231.
s p
/ )#
Configuring PPP
Table 39.
Initial WAN configuration
on
on page 223.
Configuring
Issue 3 February 2007
on
217