Configuring The Console Device - Avaya G250 Administration

Configuring the G250 and G350 for modem use
Note:
If the G250/G350 firmware is replaced by an earlier firmware version, the ppp
Note:
chap-secret is erased, and must be re-configured.
- ras — reserved for future use
- none — no password is sent
Note:
This command changes the PPP authentication parameters of the USB port as
Note:
well as the console port, even if you use the command in console interface
context.
Use the shutdown command to disconnect an active PPP session and shut down the
●
modem.
Use the timeout absolute command to set the number of minutes until the system
●
automatically disconnects an idle PPP incoming session. By default, there is no timeout.
Use the load-interval command to set the load calculation interval for the interface.
●

Configuring the console device

When you use a console device to access the CLI through the console port, you must configure
the serial connection on the console device to match the configuration of the console port. The
console port uses the following settings:
baud — 9600
●
data bits — 8
●
parity — none
●
stop bits — 1
●
flow control — hardware
●
212 Administration for the Avaya G250 and Avaya G350 Media Gateways