Administering Station Parameters - Avaya G250 Administration

Media gateways

Hide thumbs Also See for G250:

Table of Contents

Administering Station parameters

1. At the gateway command prompt, type station extension class and press Enter to

enter a second-level subcontext to administer each phone that you want covered by SLS.

In this command, extension is a 1-13 digit numeric string that may begin with "0", and

class is analog, dcp, or ip.

The command line prompt changes to sls-station <extension> to indicate that you

are in the station context for SLS administration. Typing exit ends the station

configuration mode, and the command line prompt returns to its original state. If you want

to remove the station from the SLS administration, type clear extension extension

at the command line interface. Type exit to leave the second-level station context to

return to the (super-survivable-call-engine)# context.

station 1234567 ip administers an IP phone with the extension "1234567".

2. Depending on the class (analog, dcp, or ip in Step 1), type set type model, where

model is a value from

Table 25: Class values in SLS station context

dcp6408 (default)

Issue 3 February 2007

Configuring SLS