Accessing Cli Via Local Network; Accessing Cli With A Console Device; Accessing The Cli Via Modem; Accessing The Cli Via A Usb Modem - Avaya G250 Administration

Accessing CLI via local network

Access the CLI from a computer on the same local network as the Avaya G250/G350 Media
Gateway by using ssh or, if telnet is active, any standard telnet program. Use the IP address of
any G250/G350 interface for the host address.

Accessing CLI with a console device

Use one of the following types of console devices to access the CLI:
Serial terminal
●
Laptop with serial cable and terminal emulator software
●
Connect the console device to the console port (CONSOLE) on the front panel of the Avaya
G250/G350 Media Gateway. Use only an approved Avaya serial cable. For more information
about approved Avaya serial cables, see Overview for the Avaya G250 and Avaya G350 Media
Gateways, 03-300435.
For more information about the console port, see
use on page 211.

Accessing the CLI via modem

You can use any standard telnet program to access the CLI from a remote location. This is done
by using a dialup PPP network connection from a modem at the remote location. You can use
either a USB modem connected to the USB port on the front panel of the G250/G350 or a serial
modem connected to the console port on the front panel of the G250/G350. You must only use
an approved Avaya serial cable. For more information about approved Avaya serial cables, see
Overview for the Avaya G250 and Avaya G350 Media Gateways, 03-300435.
Note:
You can disconnect a telnet session by typing <Ctrl>+]. This is particularly useful
Note:
if the normal telnet logout does not work.

Accessing the CLI via a USB modem

1. Connect a modem to the USB port on the front panel of the Avaya G250 or G350 Media
Gateway. Use a USB cable to connect the modem. The G250/G350 supports the Multitech
MultiModem USB, MT5634ZBA-USB-V92.
Accessing the CLI via modem
Configuring the console port for modem
Issue 3 February 2007 37