Avaya G250 Administration page 168

Configuring Standard Local Survivability (SLS)
15. For ISDN trunks, type set send-name method to define whether or not the calling,
connected, called, or busy party's administered name is sent to the network on outgoing or
incoming calls. method can be one of the following:
no: The name is not sent to the network for incoming or outgoing calls.
●
yes: The name is sent to the network for incoming or outgoing calls.
●
restricted: The name is sent to the network as "Presentation restricted.'
●
Note:
For this release, specify method as no since sending a Calling Party Name is a
Note:
future feature.
16. For ISDN trunks, type set send-number method to define whether or not the calling,
connected, called, or busy party's administered number is sent to the network on outgoing
or incoming calls. method can be any of the following:
no: The number is not sent to the network for incoming or outgoing calls.
●
yes: The number is sent to the network for incoming or outgoing calls.
●
restricted: The number is sent to the network as "Presentation restricted.'
●
Note:
For this release, specify method as no since sending a Calling Party Number is a
Note:
future feature.
17. For ISDN trunks, type set numbering-format type to specify the numbering plan for
this trunk in Standard Local Survivability (SLS). The numbering plan encodes the
Numbering Plan Indicator and Type of Number fields in the Calling/Connected Party
Number IE in the ISDN protocol. type can be any of the following:
unknown: Both the Numbering Plan Indicator and Type of Number are unknown.
●
public: The Numbering Plan Indicator meets the E.164 standard and the Type of
●
Number is national.
Note:
The SLS application is intended to operate into PSTN trunk interfaces. For this
Note:
reason, the only two choices for network numbering plans identification are
public (E.464) and unknown (no particular plan).
For this release, specify type as unknown since SLS does not currently support
an administrative table to calculate the Calling Party Number to be consistent with
the numbering plan of the PSTN service provider.
18. For non-ISDN digital trunks, analog loop-start and analog ground-start trunks, type set
incoming-destination extension to identify an extension to receive an incoming
trunk call, for example, an attendant or a voice response/recording system.
19. For non-ISDN digital trunks, type set incoming-dialtone yes | no to specify
whether to provide a dial tone in response to far-end trunk group seizures.
168 Administration for the Avaya G250 and Avaya G350 Media Gateways