Configuring The Primary Management Interface (Pmi); Setting The Pmi Of The G250/G350 - Avaya G250 Administration

Media gateways
Hide thumbs Also See for G250:
Table of Contents

Advertisement

Basic device configuration

Configuring the Primary Management Interface (PMI)

The Primary Management Interface (PMI) address is the IP address of an interface that you can
specify on the Avaya G250/G350 Media Gateway. The first IP address you configure on the
G250/G350 automatically becomes the PMI. You can subsequently assign any IP interface to
be the PMI.
The PMI is used as the IP address of the G250/G350 for the following management functions:
Registration of the G250/G350 to an MGC
Sending SNMP traps
Opening telnet sessions from the G250/G350
Sending messages from the G250/G350 using FTP and TFTP protocol
You can designate any of the G250/G350's interfaces to serve as the G250/G350's PMI. The
PMI must be an IP address that the MGC recognizes. If you are not sure which interface to use
as the PMI, check with your system administrator.

Setting the PMI of the G250/G350

1. Use the interface command to enter the context of the interface to which you want to
set the PMI. For example, to use the VLAN 1 interface as the PMI, type interface
vlan 1.
Note:
If the interface has not been defined, you must define it now.
Note:
2. Type the pmi command.
3. Type exit to return to general context.
4. Type the copy running-config startup-config command. This saves the new
PMI in the startup configuration file.
5. Use the reset command to reset the G250/G350.
Note:
Most configuration changes take effect as soon as you make the change, but
Note:
must be saved to the startup configuration file in order to remain in effect after you
reset the G250/G350. The PMI address is an exception. A change to the PMI
does not take effect at all until you reset the G250/G350.
6. To verify the new PMI, type the show pmi command in general context. If you use this
command before you reset the G250/G350, it displays two different PMIs:
Active PMI — the PMI the G250/G350 is currently using, as defined in the running
configuration file
70 Administration for the Avaya G250 and Avaya G350 Media Gateways

Advertisement

Table of Contents
loading

This manual is also suitable for:

G350

Table of Contents