Avaya G250 Administration page 160

Configuring Standard Local Survivability (SLS)
4. If the BRI link is employed with ISDN, and the glare-handling convention is specified as
peerMaster or peerSlave for the ISDN link (set in Step 3), type set side side to
specify the glare mode: either a or b.
5. If the BRI link is employed with ISDN, type set country-protocol country-code to
specify the ISDN Layer-3 country protocol type, where country-code is any the values
listed in
6. If the BRI link is employed with ISDN, type set bearer-cability bearer to set the
Information Transfer Rate field of the Bearer Capability IE, where bearer is any of the
following values:
3khz: 3.1kHz audio encoding
●
speech: Speech encoding
●
7. Type set interface-companding type to set the far-end companding method,
where type is any of the following values:
alaw: A-law companding
●
ulaw: U-law companding
●
8. If the BRI link is employed with ISDN, type set tei-assignment tei to select the
method by which the Layer 2 (LAPD) protocol obtains its Terminal Endpoint Identification
(TEI) address. tei is any of the following values:
auto: TEI is assigned by the network provider
●
zero: TEI is fixed
●
9. Type set directory-number-a number to assign a directory number to the B1
channel of the BRI link. number is the provisioned number received from the network
provider. The number value must be identical to the number the network provider has
assigned to the circuit.
10. Type set directory-number-b number to assign a directory number to the B2
channel of the BRI link. number is the provisioned number received from the network
provider. The number value must be identical to the number the network provider has
assigned to the circuit.
11. Type set spid-a number to assign a SPID to the B1 channel of the BRI link.
12. Type set spid-b number to assign a SPID to the B2 channel of the BRI link.
Note:
All BRI links must have SPIDs properly configured for the link to function. SPIDs
Note:
are received from the network service provider.
13. If the BRI link is employed with ISDN, type set-endpoint-init {yes | no} to
determine whether or not the far-end supports endpoint initialization.
14. If the BRI link is employed with ISDN, type set layer1-stable {yes | no}
to determine whether or not to keep the physical layer active (stable) between calls. Some
European countries, France, for example, require that the physical layer is deactivated
when there is no active call.
160 Administration for the Avaya G250 and Avaya G350 Media Gateways
Table 27.