Configuration Example For Site B - Avaya G250 Administration

Configuring WAN interfaces
* Description of footnoted commands (also applies to identical stages in configuring Site B):
(1) At this stage you apply Priority 7 to Voice Control traffic.
(2) At this stage you apply Priority 6 to RTP traffic.
(3) At this stage you apply maximum trust between 802.1p priority and DSCP.
(4) At this stage the number of connections (20) depends on the number of phones.
(5) At this stage you are matching the RTP port range to that of the G350.
(6) At this stage the default queue size is 6, and since RTP is enabled you can double the VoIP
queue size.

Configuration Example for Site B

You can configure PPP VoIP on the G350 at Site B.
Loopback and PMI interfaces configuration:
●
G350-001# interface Loopback 1
G350-001(if:Loopback1)# ip address 4.4.4.11 32
Done!
G350-001(if:Loopback 1)# pmi
The Primary management interface has changed. Please copy the running configuration
to the start-up configuration file, and reset the device.
G350-001(if:Loopback1)# exit
G350-001# copy running-config startup-config
G350-001# reset
VLAN interface configuration:
●
G350-001# interface Vlan 1
G350-001(if:Vlan 1)# ip address 3.3.3.1 24
G350-001(if:Vlan 1)# exit
G350-001# interface Vlan 2
G350-001(if:Vlan 1:2)# ip address 33.33.33.1 24
G350-001(if:Vlan 1:2)# exit
Serial interface configuration:
●
G350-001# controller t1 5/1
G350-001(controller:5/1)# channel-group 1 timeslots 1-2 speed 64
G350-001(controller:5/1)# exit
G350-001# interface Serial 5/1:1
G350-001(if:Serial 5/1:1)# ip address 2.2.2.2 24
G350-001(if:Serial 5/1:1)# mtu 300
Note:
Some LAN data applications do not support fragmented packets. In this case, do
Note:
not change the MTU from its default of 1500.
276 Administration for the Avaya G250 and Avaya G350 Media Gateways