Lldp Configuration; Supported Ports For Lldp - Avaya G250 Administration

Configuring Ethernet ports

LLDP configuration

1. Enable the LLDP agent globally using the set lldp system-control command.
G250-001(super)# set lldp system-control enable
Done!
The device's global topology information, including all mandatory TLVs, is now available to
neighboring devices supporting LLDP.
2. Configure the administrative LLDP port status using the set port lldp command
(optional). The default value is rx-and-tx.
G250-001(super)# set port lldp 10/3 rx-and-tx
Done!
The device now sends LLDP TLVs and accepts LLDP TLVs from neighboring devices
supporting LLDP on the specified port.
3. Configure additional TLVs transmission using the set port lldp tlv command
(optional). This allows you to advertise additional data about the device's and port's VLAN
information, VLANs, and system capabilities. Additional TLVs are disabled by default.
G250-001(super)# set port lldp tlv 10/3 enable all
Done!
The device now advertises all mandatory and optional TLVs to neighboring network
devices supporting LLDP.
4. Verify LLDP advertisements using the show lldp command.

Supported ports for LLDP

Only designated ports can be configured to support LLDP.
For the G250, module 10, ports 3-10. This includes all Ethernet LAN ports on the G250
●
connecting directly to the chassis.
Note:
On the G250-DCP, only ports 3 and 4 are Ethernet LAN ports.
Note:
For the G350, module 6, ports 1-24 and 51, if an MM314 media module is installed, or
●
ports 1-40 and 51 if an MM316 media module is installed. This includes all Ethernet ports
on the G350 other than the Ethernet WAN port connecting directly to the chassis.
186 Administration for the Avaya G250 and Avaya G350 Media Gateways