Configuring Switch Ethernet Ports; Switch Ethernet Port Commands - Avaya G250 Administration

Configuring switch Ethernet ports

For basic configuration of a switch Ethernet port, use the commands listed below. You can also
configure the following features on a switch Ethernet port:
Advanced switching features, including VLANs. For more information, see
●
Chapter 16: Configuring advanced
VoIP queuing. To configure VoIP queuing on a switch port, configure a VLAN for the port.
●
Then configure VoIP queuing on the VLAN. For more information about VoIP queuing, see
Configuring QoS parameters
Access control policy lists and QoS policy lists. To configure policy lists on a switch port,
●
configure a VLAN for the port. Then configure policy on the VLAN. For more information
on policy lists, see
SNMP Link Up and Link Down traps. For more information, see
●
traps on page 295.

Switch Ethernet port commands

Use the following commands for basic configuration of switch Ethernet ports. For more
information about these commands, see Avaya G250 and Avaya G350 CLI Reference,
03-300437.
Use the set port auto-negotiation-flowcontrol-advertisement command
●
to set the flowcontrol advertisement for the specified port when performing
auto-negotiation. This command is only applicable to the Gigabit Ethernet port.
Use the set port disable command to disable a port or range of ports.
●
Use the set port duplex command to configure the duplex type of an Ethernet or Fast
●
Ethernet port or range of ports.You can configure Ethernet and Fast Ethernet interfaces to
either full duplex or half duplex. The duplex status of a port in auto-negotiation mode is
determined by auto-negotiation. When auto-negotiation is enabled, an error message is
generated if you attempt to set the transmission type of auto-negotiation Fast Ethernet
ports to half-duplex or full-duplex mode.
Use the set port edge admin state command to determine whether or not the port
●
is an edge port. Edge port is a treatment assigned to ports for the purposes of RSTP
(Rapid Spanning Tree Protocol). For more information about using this command and
RSTP configuration in general, see
Note:
This command is not supported by the G250.
Note:
Use the set port enable command to enable a port or a range of ports.
●
switching.
on page 206.
Chapter 20: Configuring
Rapid Spanning Tree Protocol (RSTP)
Configuring switch Ethernet ports
policy.
Configuring SNMP
Issue 3 February 2007
on page 322.
177