Configuring A Site-To-Site Ipsec Vpn; Installing The Vpn License File; Configuring Ipsec Vpn; Prerequisites - Avaya G250 Administration

Configuring IPSec VPN

Configuring a site-to-site IPSec VPN

This section describes the procedures for VPN configuration.

Installing the VPN license file

To enable IPSec VPN you must obtain and install a VPN license. For information on obtaining a
VPN license, see Installing and Upgrading the Avaya G250 Media Gateway, 03-300434 or
Installing and Upgrading the Avaya G350 Media Gateway, 03-300394.
You can install the VPN license via FTP, TFTP, or SCP.
Note:
You must have admin permissions to install a VPN license.
Note:
1. Use one of the following commands:
● copy ftp license-file filename ip
copy tftp license-file filename ip
●
copy scp license-file filename ip
●
where:
●
●
For example:
2. Optionally, use the show download license-file status command to view the
status of the download process.
3. Use the show license status command to verify that the license was installed.
4. Use the copy running-config startup-config command to save your current
configuration.
5. Reset using the reset command.
Configuring IPSec VPN

Prerequisites

As a prerequisite to configuring IPSec VPN, a valid VPN license must be installed on the G250/
G350. For details, see
454 Administration for the Avaya G250 and Avaya G350 Media Gateways
filename – the filename, including the full path
ip – the ip address of the ftp/tftp/scp server.
copy tftp license-file my_license_file.xml 198.87.134.153
Installing the VPN license file on page 454.