Defining List Identification Attributes - Avaya G250 Administration

To create or edit an access control list, type ip access-control-list, followed by a list
number in the range 300-399. The G250/G350 includes one pre-configured access control list.
The pre-configured access control list is list number 300. To create a new access control list,
type:
ip access-control-list 301
To create or edit a QoS list, type ip qos-list, followed by a list number in the range 400-499.
The G250/G350 includes one pre-configured QoS list. The pre-configured QoS list is list
number 400. To create a new QoS list, type:
ip qos-list 401
Once you have entered the list context, you can perform the following actions:
Configure rules — see
●
Configure composite operations — see
●
Configure DSCP mapping (QoS lists only) — see
●

Defining list identification attributes

The policy list attributes including name, owner, and cookie, are used by Avaya QoS Manager
software to identify policy lists.
1. Enter the context of the policy list in which you want to define the attribute.
2. Enter one of the following commands, followed by a text string or integer:
- name — defines a list name (text string). The default value is owner.
- owner — defines a list owner (text string). The default value is list#<listnumber>.
- cookie — defines a list cookie (integer). The Avaya QoS Manager uses the cookie
attribute internally. Normally, you should not change this attribute.
To set a policy list attribute to its default setting, use the no form of the appropriate command.
For example, to set a list to its default name, use the command no name.
To view the attributes, use the show list command in the context of the list.
Defining rules on page 539
Composite operations
Defining policy lists
on page 545
DSCP table on page 548
Issue 3 February 2007 535