Wan Ethernet Port Traffic Shaping; Backup Interfaces; Wan Ethernet Port Commands - Avaya G250 Administration

Access control policy lists and QoS policy lists. For more information, see
●
Chapter 20: Configuring
SNMP Link Up and Link Down traps. For more information, see
●
traps on page 295.

WAN Ethernet port traffic shaping

You can use traffic shaping to determine the data transfer rate on the WAN Ethernet port. To set
traffic shaping, use the traffic-shape rate command in the interface context. To disable
traffic shaping, use the no form of the traffic-shape rate command. Traffic shaping works
in tandem with the configured bandwidth. If you change the traffic shape rate, this automatically
changes the bandwidth. Similarly, if you change the bandwidth, this automatically changes the
traffic shape rate.
Note:
The traffic shape rate is determined in bits. The bandwidth is determined in
Note:
kilobytes.
For information on traffic shaping in general, see

Backup interfaces

You can configure backup relations between a pair of any Layer 2 serial interfaces, including the
Fast Ethernet interface. For instructions on how to configure backup interfaces, see
interfaces on page 232.

WAN Ethernet port commands

Use the following commands in FastEthernet 10/2 context for basic Ethernet configuration of
the WAN Ethernet port:
Use the autoneg command to set the port speed and duplex to auto-negotiation mode for
●
the external Fast Ethernet port. Use the no form of this command to disable the
auto-negotiation mode.
Use the duplex command to control the duplex setting for the interface.
●
Use the shutdown command to set the administrative status of the current interface to
●
down. Use the no form of this command to restore the administrative status of the
interface to up.
Use the speed command to set the port speed.
●
policy.
Configuring QoS parameters
Configuring the WAN Ethernet port
Configuring SNMP
on page 206.
Issue 3 February 2007
Backup
179