Avaya G250 Administration page 228

Configuring WAN interfaces
Table 41: PPPoE commands (continued)
Commands
mtu
pppoe-client
wait-for-ipcp
pppoe-client
persistent delay
pppoe-client
persistent
max-attempts
shutdown followed by no
shutdown
show ppp
authentication
keepalive-track
ppp chap refuse
ppp pap refuse
ppp ipcp dns request
exit
copy running-config
startup-config
shutdown
228 Administration for the Avaya G250 and Avaya G350 Media Gateways
Description
Sets the interface's MTU to 1492 which ensures that overall
packet size for the PPPoE interface will not exceed 1500
which is the MTU for Ethernet.
Sets the amount of time (in seconds) between establishment
of the PPPoE tunnel and establishment of the IPCP tunnel.
If this time is exceeded, the PPPoE client terminates the
PPPoE tunnel.
Sets the interval between pppoe-client dial attempts.
Limits the number of consecutive connection establishment
retries.
Resumes trying to establish connections by shutting down and
reopening the interface.
Displays the interface's PPP authentication status.
Binds interface status to an object tracker. When activated, the
object tracker sends health checks packets at defined
intervals to the other side of the interface. If the configured
number of consecutive keepalive requests are not answered,
the interface track state changes to down. The object tracker
continues monitoring the interface, and when its track state
changes to up, the interface state changes to up.
Prevents the device from authenticating with CHAP after the
device is requested by the remote peer.
Prevents the device from authenticating with PAP after the
device is requested by the remote peer.
Requests the list of available DNS servers from the remote
peer during the PPP/IPCP session. The DNS servers are
used by the DNS Resolver to resolve host names to IP
addresses.
Returns to general context.
Saves the configuration.
Shuts down the port, and the PPPoE client, if configured.
2 of 2