Avaya G250 Administration page 226

Configuring WAN interfaces
5. You can use the following commands to change the interface parameters:
- pppoe-client service name
- mtu
- pppoe-client wait-for-ipcp
- pppoe-client persistent delay
- pppoe-client persistent max-attempts
- ppp chap refuse or ppp pap refuse
- keepalive-track
- shutdown followed by no shutdown commands
- show ppp authentication
Example using the shutdown command:
G350-001(super)# interface FastEthernet 10/2
G350-001(super-if:FastEthernet 10/2)#
G350-001(super-if:FastEthernet 10/2)# shutdown
Interface FastEthernet 10/2, changed state to administratively down
Line protocol on FastEthernet 10/2, changed state to down
Done!
The show ppp authentication command displays the following:
[PAP refuse]
PAP sent-username: [not] configured
[CHAP refuse]
CHAP hostname: <used CHAP hostname>
For example:
G350-001(super-if:FastEthernet 10/2)# show ppp authentication
PAP sent-username: configured
CHAP refuse
CHAP hostname: G350
For more information on the PPoE commands, see
6. If the G250/G350 is connected to the Internet via the Fast Ethernet interface configured for
PPPoE, and you define a VPN tunnel which specifies remote hosts by name, it is
recommended to use the ppp ipcp dns request command.
7. Type exit to return to general context. The prompt returns to:
G350-001(super)#
8. Test the configuration. See
page 231.
226 Administration for the Avaya G250 and Avaya G350 Media Gateways
Verifying the WAN configuration and testing connectivity
Table 41.
on