Avaya G250 Administration page 133

7. Identify the G350 modules and check for provisioned trunk ports.
8. At the SAT, type display port portid, where the portid is the analog trunks port on
the target gateway.
The system reports the Trunk Group Number/Member Number for this particular port.
9. Once you know the Trunk Group Number, gather trunk-group information according to
Table 15.
Table 15: Trunk group data to assemble for SLS
*
Page Field Name
1 Group Type
1 Outgoing Dial
Type
1 Trunk Group
Number
1 TAC
4 Port
1 Digit Treatment
1 Digits
Notes
This field specifies the type of trunks associated with this
trunk group.
The only acceptable values are tone and rotary. If the
field is set to 'automatic' or 'mf', then the value of 'tone' is
used instead.
Note that this does not apply to DS1 PRI links.
This value is used in the routing table.
This value is only necessary if the Dial Access? field is
set to y. If that field is set to n, this the TAC value is not
pushed down to the media gateway.
There may be more than one port within a trunk group
definition that pertains to a given media gateway.
This only applies for DID analog trunks or for DS1 tie
trunks.
Note that this does not apply to DS1 PRI tie trunks.
This field only has value when the Digit Treatment field is
set to insert1, insert2, insert3, or insert4.
Configuring SLS
1 of 3
Issue 3 February 2007 133