Step 2. Connect And Set Up The Oscilloscope; Using The Usb (Device) Interface; Using The Lan Interface; Using The Gpib Interface - Agilent Technologies Infiniium 90000 Series Programmer's Manual

Step 2. Connect and set up the oscilloscope

The Infiniium 90000 Series oscilloscopes have three different interfaces
you can use for programming:
• USB (device port, square connector).
• LAN. To configure the LAN interface, set up the Infiniium oscilloscope
• GPIB (on the 90000A Series and 90000 X- Series — the 90000Q- Series
When installed, these interfaces are always active.

Using the USB (Device) Interface

1

Using the LAN Interface

1
2
3

Using the GPIB Interface

1
2
Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference
on the network as you would any other computer with the Windows XP
operating system.
would require the N4865A GPIB- to- LAN adapter).
Connect a USB cable from the controller PC's USB port to the "USB
DEVICE" port on the back of the oscilloscope.
This is a USB 2.0 high- speed port.
If the controller PC is not already connected to the local area network
(LAN), do that first.
Contact your network administrator about adding the oscilloscope to
the network.
Setting up an Infiniium oscilloscope on a network is the same as setting
up any other computer with the Windows XP operating system.
Connect the oscilloscope to the local area network (LAN) by inserting
LAN cable into the "LAN" port on the oscilloscope.
Connect a GPIB cable from the controller PC's GPIB interface to the
"GPIB" port on the oscilloscope.
Configure the oscilloscope's GPIB interface:
In the Agilent Infiniium software interface, choose Utilities > Remote
a
Setup....
In the Remote Setup dialog, use the GPIB Address field to set the
b
address.
2
Setting Up
45