Protocol Operation; Protocol Exceptions; Suffix Multiplier - Agilent Technologies Infiniium 90000 Series Programmer's Manual

only talk when it has received a valid query message, and therefore has
something to say. The computer should only attempt to read a response
after sending a complete query message, but before sending another
program message.
Remember this Rule of Oscilloscope Communication
N O T E
The basic rule to remember is that the oscilloscope will only talk when prompted to, and it
then expects to talk before being told to do something else.

Protocol Operation

When you turn the oscilloscope on, the input buffer and output queue are
cleared, and the parser is reset to the root level of the command tree.
The oscilloscope and the computer communicate by exchanging complete
program messages and response messages. This means that the computer
should always terminate a program message before attempting to read a
response. The oscilloscope will terminate response messages except during
a hard copy output.
After you send a query message, the next message should be the response
message. The computer should always read the complete response message
associated with a query message before sending another program message
to the same oscilloscope.
The oscilloscope allows the computer to send multiple queries in one
query message. This is called sending a "compound query". Multiple
queries in a query message are separated by semicolons. The responses to
each of the queries in a compound query will also be separated by
semicolons.
Commands are executed in the order they are received.

Protocol Exceptions

If an error occurs during the information exchange, the exchange may not
be completed in a normal manner.

Suffix Multiplier

The suffix multipliers that the oscilloscope will accept are shown in
Table
Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference
2.
Message Communication and System Functions
5
101