Measure:rjdj:all - Agilent Technologies Infiniium 90000 Series Programmer's Manual

25
Measure Commands

:MEASure:RJDJ:ALL?

Query
This command is only available when the N5400A/N5401A Software is installed.
N O T E

:MEASure:RJDJ:ALL?

The :MEASure:RJDJ:ALL? query returns all of the RJDJ jitter
measurements. These values are returned as comma separated values using
the following format:
Returned Format
[:MEASure:RJDJ:ALL<space>]
TJ(<format>),<result>,<state>,
RJ(<format>),<result>,<state>,
DJ(<format>),<result>,<state>,
PJ(<format>),<result>,<state>,
BUJ(<format>),<result>,<state>,
DDJ(<format>),<result>,<state>,
DCD,<result>,<state>,
ISI(<format>),<result>,<state>,
Transitions,<number_of_transitions>,<transitions_state>,
Scope RJ(<format>),<result>,<state>,
DDPWS,<result>,<state>,
ABUJ(<format>),<result>,<state><NL>
Whether some of these values are included or not depends on the setting of
N O T E
:MEASure:RJDJ:METHod and :MEASure:RJDJ:REPort.
For example, when :MEASure:RJDJ:REPort or :MEASure:RJDJ:METHod is SPECtral, the
BUJ and ABUJ values are not returned, and there are two PJ values (one "rms" and one
"dd").
<space>
White space (ASCII 32) character.
<format> The format value tells you something about how the measurement is made.
For instance, TJ(1E- 12) means that the TJ measurement was derived using
a bit error rate of 1E- 12. A format of (rms) means the measurement is a
root- mean- square measurement. A format of (dd) means the measurement
uses a dual- Dirac delta model to derive the measurement. A format of
(pp) means the measurement is a peak- to- peak measurement.
<result> The measured results for the RJDJ measurements. A value of 9.99999E+37
means that the oscilloscope was unable to make the measurement.
<state>
The measurement result state. See
descriptions of the result state value.
618
Table 24
Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference
for a list of values and