Channel<N>:Probe:precprobe:bandwidth - Agilent Technologies Infiniium 90000 Series Programmer's Manual

:CHANnel<N>:PROBe:PRECprobe:BANDwidth
Command
:CHANnel<N>:PROBe:PRECprobe:BANDwidth {AUTO | {MANual, <bandwidth>}
The :CHANnel<N>:PROBe:PRECprobe:BANDwidth command specifies how
the limit of PrecisionProbe or PrecisionCable correction/boosting is
determined.
<N>
An integer, 1- 4.
AUTO
PrecisionProbe or PrecisionCable normally sets the bandwidth to a value
that has a small amount of boosting in the frequency response.
MANual,
Let you manually specify a bandwidth limit at which to stop applying
<bandwidth>
correction.
BOOSt, Lets you specify a dB limit at which to stop applying correction.
<boost_dB>
Example
This example specifies that, for PrecisionProbe or PrecisionCable on
channel 1, correction/boosting should stop being applied at a 3 dB limit.
myScope.WriteString ":CHANNEL1:PROBE:PRECprobe:BANDwidth BOOSt, 3"
Query
:CHANnel<N>:PROBe:PRECprobe:BANDwidth?
The :CHANnel<N>:PROBe:PRECprobe:BANDwidth? query returns the
current PrecisionProbe or PrecisionCable corrected bandwidth setting for
the selected channel.
Returned Format
[:CHANnel<N>:PROBe:PRECprobe:BANDwidth] {AUTO | {MANual, <bandwidth>}
See Also •
•
•
•
Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference
":CHANnel<N>:PROBe:ACCAL"
":CHANnel<N>:PROBe:PRECprobe:MODE"
":CHANnel<N>:PROBe:PRECprobe:CALibration"
":CHANnel<N>:PROBe:PRECprobe:ZSRC"
| {BOOSt, <boost_dB>}}
| {BOOSt, <boost_dB>}}<NL>
on page 217
on page 237
on page 236
on page 238
12
Channel Commands
235