Measure:vpp - Agilent Technologies Infiniium 90000 Series Programmer's Manual

:MEASure:VPP

Command
:MEASure:VPP [<source>]
The :MEASure:VPP command measures the maximum and minimum
voltages on the selected source, then calculates the peak- to- peak voltage
as the difference between the two voltages. Sources are specified with the
:MEASure:SOURce command or with the optional parameter following the
:MEASure:VPP command.
<source> {CHANnel<N> | FUNCtion<F> | WMEMory<N> | CLOCk | MTRend |
MSPectrum | EQUalized}
MTRend and MSPectrum sources are only available if the oscilloscope has
the EZJIT option installed and the feature is enabled.
The CLOCk source is only available if the oscilloscope has the High Speed
Serial option installed and the feature is enabled.
The EQUalized source is only available if the oscilloscope has the High
Speed Serial option and the Serial Data Equalization option installed and
the features are enabled. This command uses the Feed- Forward Equalized
(FFE) signal as the source.
<N>
CHANnel<N> is an integer, 1- 4.
WMEMory<N> is an integer, 1- 4.
<F> FUNCtion<F> is an integer, 1- 16.
Example
This example measures the peak- to- peak voltage or FFT amplitude range
of the previously selected source.
myScope.WriteString ":MEASURE:VPP CHANNEL1"
Query
:MEASure:VPP? [<source>]
The :MEASure:VPP? query returns the specified source peak- to- peak
voltage.
Returned Format
[:MEASure:VPP] <value>[,<result_state>]<NL>
<value>
Peak- to- peak voltage of the selected source.
<result_state> If SENDvalid is ON, the result state is returned with the measurement
result. See the :MEASure:RESults table in this chapter for a list of the
result states.
Example This example places the current peak- to- peak voltage in the numeric
variable, varVoltage, then prints the contents of the variable to the
computer's screen.
Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference
25
Measure Commands
683