Autoscale:vertical - Agilent Technologies Infiniium 90000 Series Programmer's Manual

27
Root Level Commands

:AUToscale:VERTical

Command
:AUToscale:VERTical {CHANnel<N>}
The :AUToscale:VERTical command autoscales the vertical position and
scaling for the corresponding channel without changing anything else (for
example, trigger or timebase settings).
Example
This example automatically autoscales the vertical position and scale for
the waveform on Channel 1.
myScope.WriteString ":AUTOSCALE:VERTical CHAN1"
If you are using software 2.10 or earlier, the command syntax is (lower-case "t" in
N O T E
"vertical"):
AUToscale:VERTical <CHANnel 1 | CHANnel 2 | CHANnel 3 | CHANnel 4>
Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference 711