What's New In Version 3.50 - Agilent Technologies Infiniium 90000 Series Programmer's Manual

What's New in Version 3.50

New command descriptions for Version 3.50 of the Infiniium
90000A/90000X Series oscilloscope software appear below.
New Commands
Command
:CHANnel<N>:PROBe:AUToze
ro (see
:CHANnel<N>:PROBe:HEAD:
VTERm (see
:CHANnel<N>:PROBe:MODE
(see
:FUNCtion<N>:MTRend (see
page
:FUNCtion<N>:MHIStogram
(see
:LISTer Commands (see
page
:MEASure:HISTogram:RESolut
ion (see
:MEASure:NOISe (see
page
:MEASure:NOISe:ALL (see
page
:MEASure:NOISe:BANDwidth
(see
:MEASure:NOISe:LOCation
(see
:MEASure:NOISe:RN (see
page
:MEASure:NOISe:SCOPe:RN
(see
:MEASure:NOISe:STATe (see
page
:MEASure:NOISe:UNITs (see
page
:MEASure:RJDJ:RJ (see
page
Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference
page 219)
page 232)
page 234)
352)
page 350)
413)
page 555)
580)
581)
page 583)
page 584)
587)
page 588)
589)
590)
631)
Description
Initiates the N2893A probe's auto degauss/ offset cal.
Sets the termination voltage for the N5444A probe head.
Sets the N2750A probe's InfiniiMode configuration.
New Meas Trend math function.
New Meas Histogram math function.
For displaying and retrieving data from the serial decode listings.
The bin width value of one bar in the histogram.
Adds a Noise measurement to the oscilloscope display (like
Measure > Data > Noise from the front panel) or gets the
measured noise value.
Returns the NOISe measurement results for the "zeros" or
"ones" level.
Sets the type of filtering used to separate the data dependent
noise from the random noise and the periodic noise.
Specifies the noise measurement location within the bit where
0% is the beginning of the bit, 50% is the middle of the bit, and
100% is the end of the bit.
Specifies a known amount of random noise.
Specifies the removal of the oscilloscope's calibrated random
noise from the reported RN.
Enables or disables the NOISe measurements.
Sets the unit of measure for NOISe measurements to volts or
unit amplitude.
Specifies a known amount of random jitter.
1
What's New
37