Agilent Technologies Infiniium 90000 Series Programmer's Manual page 79

3
Introduction to Programming
The easiest method of receiving a digitized waveform depends on data
structures, available formatting, and I/O capabilities. You must convert the
data values to determine the voltage value of each point. These data
values are passed starting with the left most point on the oscilloscope's
display. For more information, refer to the chapter, "Waveform Commands."
When using GPIB, you may abort a digitize operation by sending a Device
Clear over the bus.
Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference 79