Function<F>:Invert - Agilent Technologies Infiniium 90000 Series Programmer's Manual

17
Function Commands
:FUNCtion<F>:INVert
Command
:FUNCtion<F>:INVert <operand>
The :FUNCtion<F>:INVert command defines a function that inverts the
defined operand's waveform by multiplying by - 1.
<F> An integer, 1- 16, representing the selected function.
<operand> {CHANnel<n> | DIFF<P> | COMMonmode<P> | FUNCtion<F> |
WMEMory<n> | <float_value> | MTRend | MSPectrum}
See the discussion of possible operands in the introduction to
"Function Commands," starting on page 319.
Example
This example sets up function 2 to invert the waveform on channel 1.
myScope.WriteString ":FUNCTION2:INVERT CHANNEL1"
346 Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference
Chapter 17,