Iscan:measurement:ulimit - Agilent Technologies Infiniium 90000 Series Programmer's Manual

20
InfiniiScan (ISCan) Commands

:ISCan:MEASurement:ULIMit

Command
:ISCan:MEASurement:ULIMit <upper_value>
The :ISCan:MEASurement:ULIMit (upper limit) command sets the upper
test limit for the active measurement currently selected by the
:ISCan:MEASurement command.
<upper_value>
A real number.
Example
The following example sets the upper limit of the currently selected
measurement to 500 mV.
myScope.WriteString ":ISCAN:MEASUREMENT:ULIMIT 500E-3"
Suppose you are measuring the maximum voltage of a signal with Vmax,
and that voltage should not exceed 500 mV. You can use the above
program and set the :ISCan:MEASurement:FAIL OUTside command to
specify that the oscilloscope will trigger when the voltage exceeds 500 mV.
Query
:ISCan:MEASurement:ULIMit?
The query returns the current upper limit of the limit test.
Returned Format
[:ISCan:MEASurement:ULIMit] <upper_value><NL>
Example The following example returns the current upper limit of the limit test and
prints the result to the controller's screen.
myScope.WriteString ":SYSTEM:HEADER OFF"
myScope.WriteString ":ISCAN:MEASUREMENT:ULIMit?"
varValue = myScope.ReadNumber
Debug.Print FormatNumber(varValue, 0)
388 Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference
' Response headers off.