Agilent Technologies Infiniium 90000 Series Programmer's Manual page 192

12
Channel Commands
The CHANnel subsystem commands control all vertical (Y axis) functions
of the oscilloscope. You may toggle the channel displays on and off with
the root level commands :VIEW and :BLANk, or with :CHANnel:DISPlay.
In this section, you can specify differential and/or common mode channels using the
N O T E
following convention. If you have differential or common mode channels enabled (using
either the :CHANnel<N>:DIFFerential or :CHANnel<N>:COMMonmode commands) then:
•
•
•
•
192
:CHANnel<N>:PROBe:HEAD:DELete ALL
:CHANnel<N>:PROBe:HEAD:SELect
:CHANnel<N>:PROBe:HEAD:VTERm
:CHANnel<N>:PROBe:ID?
:CHANnel<N>:PROBe:MODE
:CHANnel<N>:PROBe:PRECprobe:BANDwidth
:CHANnel<N>:PROBe:PRECprobe:CALibration
:CHANnel<N>:PROBe:PRECprobe:MODE
:CHANnel<N>:PROBe:PRECprobe:ZSRC
:CHANnel<N>:PROBe:SKEW
:CHANnel<N>:PROBe:STYPe
:CHANnel<N>:RANGe
:CHANnel<N>:SCALe
:CHANnel<N>:UNITs
:CHANnel1 would refer to the Channel 1 - Channel 3 differential channel
:CHANnel2 would refer to the Channel 2 - Channel 4 differential channel
:CHANnel3 would refer to the Channel 1 + Channel 3 common mode channel
:CHANnel4 would refer to the Channel 2 + Channel 4 common mode channel
Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference
230
231
232
233
234
237
238
240
241
242
243
244
235
236