Sprocessing:ffequalizer:ntaps - Agilent Technologies Infiniium 90000 Series Programmer's Manual

30
Serial Data Equalization Commands

:SPRocessing:FFEQualizer:NTAPs

Command
:SPRocessing:FFEQualizer:NTAPs <number>
The :FFEQualizer:NTAPs command sets the number of taps to be used in
the FFE algorithm.
The indices of your FFE taps depend on the number of precursor taps
being used. For example, if you are using zero precursor taps then your
FFE tap indices would range from 0 to (NTAPs - 1). If you are using two
precursor taps then your FFE tap indices would range from - 2 to (NTAPs
- 1 - 2).
<number> an integer between 2 and 40
Example This example sets the number of FFE taps to 3.
myScope.WriteString ":SPRocessing:FFEQualizer:NTAPs 3"
Query

:SPRocessing:FFEQualizer:NTAPs?

The :SPRocessing:FFEQualizer:NTAPs? query returns the number of FFE
taps.
790 Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference