Channel<N>:Probe:mode - Agilent Technologies Infiniium 90000 Series Programmer's Manual

12
Channel Commands
:CHANnel<N>:PROBe:MODE
Command
:CHANnel<N>:PROBe:MODE {DIFF | SEA | SEB | CM}
This command is currently only valid for the N2750A probe.
N O T E
The :CHANnel<N>:PROBe:MODE command sets the N2750A probe's
InfiniiMode configuration.
If the N2750A probe is not connected to the channel you will get a
settings conflict error.
<N> An integer, 1- 4.
Example
This example sets the probe InfiniiMode for channel 1 to common mode.
myScope.WriteString ":CHANNEL1:PROBE:MODE CM"
Query
:CHANnel<N>:PROBe:MODE?
The :CHANnel<N>:PROBe:MODE? query returns the current N2750A probe
InfiniiMode setting for the selected channel.
Returned Format
[:CHANnel<N>:PROBe:MODE] {DIFF | SEA | SEB | CM}<NL>
234 Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference