Waveform:segmented:all - Agilent Technologies Infiniium 90000 Series Programmer's Manual

34
Waveform Commands

:WAVeform:SEGMented:ALL

Command
:WAVeform:SEGMented:ALL {{ON | 1} | {OFF | 0}}
The :WAVeform:SEGmented:ALL command configures the DATA query for
rapidly downloading all segments in one query.
The <start> and <size> optional parameters for the DATA query are still
supported and represent the start and size of the data for each segment.
Powering on the oscilloscope or performing a Default Setup sets this
command to OFF.
There is complete backwards compatibility when this command is set to
OFF.
The ON setting only supports channel and pod sources. If other sources
such as functions are selected, a settings conflict message appears during
the DATA query and no data is downloaded.
In segmented acquisition mode, with this command set to ON, the number
of segments is appended to end of the waveform preamble.
Example
This example turns on this command.
myScope.WriteString ":WAVeform:SEGMented:ALL ON"
Query

:WAVeform:SEGMented:ALL?

This query returns the status of this command.
970 Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference