Agilent Technologies Infiniium 90000 Series Programmer's Manual page 417

The commands in the MARKer subsystem specify and query the settings of
the time markers (X axis) and current measurement unit markers (volts,
amps, and watts for the Y axis). You typically set the Y- axis measurement
units using the :CHANnel:UNITs command.
Guidelines for Using Queries in Marker Modes
N O T E
In Track Waveforms mode, use :MARKer:CURSor? to track the position of the waveform. In
Manual Markers and Track Measurements Markers modes, use other queries, such as the
X1Position? and X2Position?, and VSTArt? and VSTOp? queries. If you use
:MARKer:CURSor? when the oscilloscope is in either Manual Markers or Track
Measurements Markers modes, it will put the oscilloscope in Track Waveforms mode,
regardless of the mode previously selected. In addition, measurement results may not be
what you expected.
Agilent Infiniium 90000 Series Oscilloscopes
Programmer's Reference
23
Marker Commands
:MARKer:CURSor? 418
:MARKer:MEASurement:MEASurement
:MARKer:MODE 420
:MARKer:X1Position 421
:MARKer:X2Position 422
:MARKer:X1Y1source 423
:MARKer:X2Y2source 424
:MARKer:XDELta? 425
:MARKer:Y1Position 426
:MARKer:Y2Position 427
:MARKer:YDELta? 428
s1
419
417