Lister:display - Agilent Technologies Infiniium 90000 Series Programmer's Manual

:LISTer:DISPlay

Command
:LISTer:DISPlay <value>
<value> ::= {OFF | ON | SBUS1 | SBUS2 | SBUS3 | SBUS4}
The :LISTer:DISPlay command configures which of the serial buses to
display in the Lister, or whether the Lister is off. "ON" or "1" is the same
as "SBUS1".
When set to "ALL", the decode information for different buses is
interleaved in time.
Serial bus decode must be on before it can be displayed in the Lister.
Query
:LISTer:DISPlay?
The :LISTer:DISPlay? query returns the Lister display setting.
Returned Format
<value><NL>
<value> ::= {OFF | ON | SBUS1 | SBUS2 | SBUS3 | SBUS4}
See Also •
•
Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference
":SBUS<N>[:DISPlay]"
":LISTer:DATA" on page 414
on page 739
22
Lister Commands
415